Laminar airflow hoods are a great improvement in the manufacturing process, because they improve the efficiency of the assembly line. When a product goes from the production floor to your hand tool shop, you want to be sure that you are producing the highest quality product possible. Quality control is imperative. You want the best tools and products, that perform at their absolute best. One tool that can greatly affect this quality of your products, is the laminar air flow system.

The clean bench laminar air flow system allows for maximum airflow while minimizing contamination. There are two types of laminar flow enclosures that are available for the production facilities. There is the horizontal laminar air flow enclosure, and the vertical laminar air flow enclosure.

Horizontal laminar means that the air moves horizontally instead of vertically. This means that the air can pass through the material in a horizontal manner without any obstacles. It also has an advantage because it allows the air to filter through the material more efficiently. The product that you are cleaning will travel through the laminar more cleanly because of this.

The vertical laminar is the opposite of the horizontal laminar. Instead of moving horizontally, the laminar moves vertically. This means that the product will go through the laminar more quickly. As it does, it also reduces the contamination of any dirt particles. If you have not experienced laminar air yet, then you are going to once you see the difference in quality with the laminars.

The different laminars can also be used for different assembly procedures. The most common is the self-aligning laminar. This laminar works by making sure that the product evenly distributes itself across the material during assembly. This means that the alignment of the product during assembly is not going to be off balance. If something is done to the laminar at any point, such as when the screws are screwed too far in or the air pressure is too low, the alignment will be off and the product will be wasted.

Other seminars are designed with special attachments to allow for some assembly within the laminar. Some of these attachments include push rods, which allows for products to go into the laminar and then be pushed back out. These attachments are often used for assembly of flat surface products such as acrylics, which are able to roll down the flat surface.

All of the laminars available have their own merits and demerits. Most seminars are effective, but only because they adhere to the surface they are attached to. When this bonding occurs, the laminar can prevent particles from being able to move around and push parts off their aligned plane. In the past, some laminars did not have this quality, but newer models have found ways to overcome this flaw. However, even though laminars have been developed to prevent particles from moving, they are still best used in assembly line situations.

Another problem with laminars is that they only work in a specific area. For example, if the air gap between two laminar layers is greater than a certain amount, the product will not be trapped. As a result, the product will be wasted, since it is impossible to make the product. It may seem difficult to think about assembly without laminars, but this is one of the reasons why they are so commonly used today. They are also the most efficient way to ensure that contaminants are not able to escape into a finished product while it is being produced. For this reason, laminar air flow measurement is necessary for every level of manufacturing.

More product

Laminar Airflow System

Laminar Airflow Trolley

laminar Airflow Work Bench

LAMINAR AIR FLOW UNITS